Documenting Seep Sites
Tuesday, August 03, 2010
Documenting all Major Seep Sites at Southern Hydrate Ridge
A half-scale model of a potential frame design is lowered off the R/V Thompson for deployment at Southern Hydrate Ridge using Medea and Jason. The frame is also being tested to see how different materials react to biofouling during long-duration deployments.
Test Frame for Regional Cabled Observatory
Following recovery of Jason from Dive J2-511, and Sentry, both vehicles had down time to adjust sensors, charge Sentry's batteries, and to prepare the vehicles for the next long dives. The science team planned out a detailed video mosaicking run with Sentry over the major seep site area. Dana Yoerger, Sentry Expedition Leader, laid out a tight gird with Sentry "flying" 4 m off the seafloor, continuously snapping photos for follow-on mosaicking. In addition, an Eh sensor, which measures reduction-oxidation potential differences in the ocean fluids, will map out zones of active seepage.
During this time, a mosaicking run by Jason was planned to thoroughly characterize the limestone Pinnacle site located ~400 m to the southwest of where Sentry will be working. This area was chosen because: 1) Sentry will be working at the major seep site, thus preventing access by Jason; 2) the Pinnacle has never been well documented; and 3) just-completed work around the Pinnacle indicates a distinct bubble plume, and Eh hits indicate active seep sites in this area. In concert, these high-resolution data sets will form an important foundation for laying out the observatory's node and instrumentation sites at Southern Hydrate Ridge.
The morning was not only an intense time for mission planning, but also for preparing to deploy a mock-up node frame for testing of design and materials. The frame measures 1.5 X 1.5 X 2 meters and weighs ~700 lbs. The plan was to deploy the frame using the Jason-associated vehicle, Medea. Upon signal, the tether, run from Medea to the frame, would be dropped and the frame released once in place on the seafloor. This operation required extensive deck and deployment planning.
Sentry went into the water in the afternoon and began its ~32-hr mission to saturation map the seafloor with digital images. After monitoring Sentry for an hour to ensure that it was functioning properly, the node frame, Jason, and Medea were launched. Jason reached the seafloor at ~ 745 m and deployed a small target. The frame was then flown into place with Medea and released within a few feet of the marker (Marker F). Jason then flew down to the Pinnacle site and began a few-hour run of flying at 80 m off the seafloor to test the RESON sonar for bathymetric mapping, followed by the beginning of a several-hour mosaicking run on the Pinnacle.